Intelbras AMT 2018 E - Page 40

40
ENTER + INSTALLER
PASSWORD
Factory default: 9090
ENTER + 512 + ENTER 1 + ENTER
Note:
» Blocks all kinds of Reset.
» Factory Default: Disabled.
ENTER + 512 + ENTER 2 + ENTER
Note:
» Blocks the Remote Controls. Activation /
Deactivation by password only.
» Factory Default: Disabled.
ENTER + 512 + ENTER 3 + ENTER
Note:
» Keyboard will be locked for 10 minutes after
the 4th attempt of access by password. It will
send a Wrong Password notication to the
monitoring company.
» Factory Default: Disabled.
ENTER + 512 + ENTER 4 + ENTER
Note:
» Blocks Activation/Deactivation via telephone.
» Factory Default: Disabled.
ENTER + INSTALLER
PASSWORD
Factory default: 9090
ENTER + 512 + ENTER 5 + ENTER
Note:
» It will send, at the moment it occurs, a
trouble event.
» Factory Default: Enabled.
ENTER + 512 + ENTER 6 + ENTER
Note:
» Use this function when you have sensors
from another manufacturer or Intelbras
1000 series sensors, which do not have
Low Battery detection.
» Factory Default: Disabled.
ENTER + 512 + ENTER 7 + ENTER
Note:
» It will display the clock when all Zones are
closed. Otherwise it will show on the dis-
play the Zones that are open.
» Factory Default: Disabled.
ENTER + 512 + ENTER 8 + ENTER
Note:
» In the event of a power failure, the battery
will be used until it is completely drained.
» Factory Default: Enabled.
ENTER + INSTALLER
PASSWORD
Factory default: 9090
ENTER + 513 + ENTER 1 + ENTER
Note:
» For siren wire cut detection, a 2k2 resis-
tor must be connected in parallel with
the siren.
» Factory Default: Disabled.
ENTER + 513 + ENTER 2 + ENTER
Note:
» It will send a Siren Trouble event, if the siren
wire is short-circuited.
» Factory Default: Disabled.
ENTER + 513 + ENTER 3 + ENTER
Note:
» Triggers the siren, even if the system is
deactivated.
» Factory Default: Disabled.
ENTER + 513 + ENTER 8 + ENTER
Note:
» Hides the editable message on the key-
board.
» Factory Default: Disabled.