Intellian v100GX - Antenna Position & Parameters

115
REMOTE ACCESS (WEB M&C)
Antenna Position & Parameters
No. Item Description
1
Antenna Setting
Set current antenna position and Search and Track-
ing parameters. These parameters should only be
changed by an authorized service technician. Im-
proper setting of these parameters will render your
system inoperable.
2
Current Antenna Position/
Target Antenna Position
Display current antenna position.
-
Relative Azimuth: display antenna relative AZ angle.
- Absolute Azimuth: display antenna absolute AZ angle.
- Elevation: display antenna elevation angle.
- LNB Pol Angle: display LNB pol angle.
- Heading: display ship’s heading information.
3
Manual Movement
Move antenna azimuth and elevation angles and
LNB pol angle to nd the desired satellite manually.
LNB Pol Angel can be adjusted at any time either in
SETUP Mode or Tracking Mode.
4
LNB Pol Sensor Calibration
Calibrate the LNB pol angle when the control board,
potentiometer or belt is replaced.
5
Elevation Adjust
Adjust the elevation to offset the angle difference
between the mechanical elevation angle and actual
elevation angle.
6
Conical Range
The relative force of the motors controlling azimuth
and elevation. Set the conical range while the an-
tenna is in tracking mode.
1
3
4
5
6
7
8
9
10
11
2