127
REMOTE ACCESS (WEB M&C)
Administration
No. Item Description
1
Wireless Setting Enter wireless setting page.
2
Wireless Network
Conguration
The E2S (Ethernet-to-Serial) supports WiFi Network. Turn
on WiFi switch on the rear panel of the ACU to activate
your WiFi networking.
- Wireless Network Mode: select an appropriate wireless
network mode for your current WiFi network enviroment.
- Wireless Network Name (SSID): The SSID is the network
name shared among all devices in a wireless network.
The SSID must be identical for all devices in the wireless
network. It is case-sensitive and must not exceed 32
alphanumeric characters, which may be any keyboard
character. Make sure this setting is the same for all
dvices in your wireless network.
- Channel: select an appropriate channel from the list
provided to correspond with your network settings. All
devices in your wireless network must use the same
channel in order to function correctly. Try to avoid conicts
with other wireless networks by choosing a channel
where the upper and lower three channels are not in use.
- Bitrate: select an appropriate bit rate for the wireless
communication. If Bitrate is set to “Auto”, the optimized
bitrate will be determined automatically. Please note that
“802.11b Only Mode” supports 1, 2, 5.5, and 11Mbps,
while “802.11g Only Mode” supports 6, 9, 12, 18, 24,
36, 48, and 54Mbps. In the mixed mode, all options are
available.
WARNING: Ensure to enter the SETUP mode before starting conguration. After
completing the modication of settings, enter Save & Reboot page and click on “Save &
Reboot” button. Without doing so, the modied settings will be lost.
1
2
To Next Page
Loading...
Need help?
General
