Intellian v100GX User Manual

v100GX – Marine Satellite Communication System
94
- Antenna Current GPS: displays and sets current antenna’s GPS.
- Heading: displays and sets current ship’s heading information.
· Heading Device: None / NMEA/ NMEA 2000/Ground Test.
The baud rate (4800/ 9600/ 19200/ 38400) must be set if NMEA is selected.
- Bow Information: displays and sets current antenna’s bow.
- Skew: displays current antenna’s skew and skew offset.
· Pol Sensor Calibration: calibrates the sensor (potentiometer).
· Mechanical Skew Offset: the mechanical skew offset is preset in the
factory with a default value (0, 1, or 2) depending on the assembly status.
Resetting of the mechanical skew offset may be required when the satellite
 TLFXPGGTFUJTVOLOPXO0WFSBMMTZTUFNTLFXPGGTFUTBUFMMJUFTLFXPGGTFU
+ mechanical skew offset). Due to each satellite has its own skew offset,
Intellian recommends you check with your service provider or satellite
operator to get the satellite skew offset value and input it in Satellite Work
Tab rather than resetting the mechanical skew offset directly.
- Antenna Angle: displays and sets current antenna’s absolute and relative AZ
(azimuth) position, EL (elevation) position and LNB Pol angle. You can move
antenna azimuth and elevation position and LNB Pol angle by using the arrows or
inputting a value to nd the desired satellite manually.
- Use Bluetooth: The data communication between the ACU and the antenna will
be terminated once the Bluetooth function is activated. The built-in Bluetooth
connection module inside of the antenna dome can enable a PC connection right
alongside the dome. For Bluetooth connection, see page 145.
· Modem Lock: turns on/off the modem lock signal sent from your PC/
laptop to the antenna while Bluetooth is in use.
· Heading Connect: turns on/off the heading signal sent from your PC/
laptop to the antenna while Bluetooth is in use.

Intellian v100GX Specifications

General

Brand	Intellian
Model	v100GX
Category	Antenna
Language	English