29
Installing Above Deck Unit (ADU)
2. Terminate N(M) connector on the end of the RF Cable. Intellian recommends using a genuine cable
connector and tools. Refer to the cable termination instructions provided by the manufacturer to
terminate the N connector.
3. Connect the terminated RF cable to the connector of the radome as the following. Ensure the cable is
rmly fastened to the connector. Fix the cable position along the routing path using cable ties, cable
mounts or cable clamps.
4. After completing cable connection, put the cover in the right place and close it by tightening the M4 x
15L wrench bolts (2 ea) by using a wrench set.
Cable Tie Bracket
To Next Page
Loading...
