Inter-Tel ECX 2000 - Maintenance Procedures; Hot Swapping Faulty Modules

EncoreCX
Installation and Maintenance Manual
45
Maintenance procedures
Faults can be rectified on-site by replacing faulty modules or PCBs (Printed Circuit Boards).
Hot swapping faulty modules
The CO Line modules can be replaced without powering the system down.
· The CO Line modules can be removed and replaced without powering down the system.
· The Extension modules can be removed and replaced without powering down the system.
· The Voice module can be removed and replaced without powering down the system.
When a Voice module is replaced, all recorded messages and greetings are lost. If a
Voice module is removed and reinserted, the messages and greetings are retained.
· The Internet Router module can be removed and replaced without powering down the system.
· The T1 (future development) module can be removed and replaced without powering down the system.