Interacoustics AT235 Instructions For Use

AT235 Instructions for Use - EN Page 16
3.4 Use of standard and clinical probe system
For establishing most stable measurements it is recommended not to hold the probe between fingers during
the measurements. Particularly acoustic reflex measurements could be affected by probe movements.
3.5 AT235 Stand-alone operation
3.5.1 AT235 Stand-alone operation panel
Name
Description
1
ON
Turns the AT235 ON and OFF.
2
Shift
Shift is used to access secondary functions of the other keys.
3
Setup
Hold down Setup and use the wheel (19) to select the desired
Setup menu then let go of the Setup button to open it.
4-13
Function keys
The 10 function keys hold functions of which labels are displayed
in the screen.
14
Tests
Hold down Test and use the wheel (19) to select the desired
protocol or audiometry or impedance module. Let go of the Test
button to make your selection.
15
New Session
Clears data and starts a new session in the current module.
16
Clients
Press the Clients button to open a window in which a client can
be selected, edited or created. Also its historic sessions can be
viewed.
17
Save
Saves the current session for the current module.
18
Print
Prints the session that is currently on screen.
19
Wheel
Used for manual pump control as well as scrolling through menus
and selection possibilities. In the audiometry module the wheel
controls the stimulus intensity.
20
Tymp
Selects or deselects a tympanogram test from the protocol.

Interacoustics AT235 Specifications

General

Brand	Interacoustics
Model	AT235
Category	Measuring Instruments
Language	English