4
NOTE If any of these items were not delivered, call the Customer Response Center immediately at
1-800-633-7248.
Save the packaging materials. If you need to return equipment for repair, it must be in its
original packaging for you to get warranty service.
If you have already unpacked and connected the peripherals to the system, review the rest of
this chapter and then go to Chapter 2, “Setting Up the Software.”
Placing System Components
CAUTION Do not use the bottom portion of the face panel or the lip at the top rear of the unit as a hand
hold when moving the system. Equipment damage and personal injury can result.
When placing the system’s components, remember these guidelines:
u
Move and place the base unit and monitor carefully.
u
Place the base unit in a location where air can circulate freely around it. The front and
back panels should each have at least a 3-inch clearance.
u
Avoid exposing the system to high levels of dust, smoke, or moisture.
u
Maintain a temperature range of 10
°
C to 26
°
C (50
°
F to 80
°
F); the optimum
operating temperature is 21
°
C (70
°
F).
u
Maintain a humidity range from 20 percent to 80 percent (non-condensing); the
optimum humidity level is 50 percent.
CAUTION Do not move the system without first shutting down the system and turning off the power, or
damage to internal components may result.
To Next Page
Loading...
