77
Follow the instructions in Introducing Windows 95 or Getting Started to install Windows 95
or Windows 98, respectively. As you install the operating system:
u
Select the default responses during the Setup process.
u
Allow Setup to configure the network only if you have an installed network adapter, and
only if the system is connected to the network.
u
Create a Startup diskette when prompted.
u
While operating system files are being copied to the system, you are prompted for the
Setup boot diskette. This occurs even if the Setup boot diskette is already inserted in the
floppy disk drive. Select OK to continue.
Next, you are notified that a CD-ROM driver file (such as OAKCDROM.SYS or
TAISATAP.SYS) could not be found on the Setup boot diskette. In the dialog that displays,
specify that the file should be copied from a:\, and then select OK.
After installing the operating system:
u
Install drivers or other system software from any backup diskettes. System software
delivered on backup diskette is usually more current than system software on the
operating system CD-ROM. Alternatively, you can install the drivers or other system
software from the Windows 95/98 CD-ROM if you don’t have them on diskette.
As shipped from the factory, the system’s hard disk drive contains Windows 95/98 Setup
files in the
C:\WINDOWS\OPTIONS\CABS directory, as compressed .CAB files. If the CABS
directory is deleted from the system’s hard disk, you must have access to a Windows
95/98 CD-ROM to use the operating system Setup files.
u
Perform any additional installation and configuration tasks described in the Late-
Breaking News document delivered with your system.
u
Configure the system as described in Chapter 3, “Configuring the System.”
u
Perform any operational changes required for your system as described in Chapter 4,
“Operating Notes.”
u
You can install MS-DOS Microstation drivers, available from the Intergraph Bulletin
Board Service (IBBS).
Installing the Creative Labs Sound Blaster Pro 16 Driver
To install the Sound Blaster Pro 16 adapter driver, use the Plug and Play feature of Windows
95/98 to install the driver. Follow the instructions found in the
README.TXT file, located in
the DRIVER directory on the SYSTEM DRIVE.
To Next Page
Loading...
