21
5. Select a resolution appropriate for your system’s monitor, and then click OK.
6. Restart the system.
Correcting Video Display Problems
If the system’s video display is black, not synchronized, or distorted after you restart the
system, you may have a video configuration problem.
On a system running Windows NT, use the Last Known Good option to return the system to
the last known good configuration recorded by Windows NT.
To use the Windows NT Last Known Good option:
1. Power down and restart the system.
2. Press the space bar at the following prompt:
Press space bar NOW to invoke the Last Known Good Menu
If the Last Known Good option fails, or if Windows 95 or Windows 98 is installed, restart
the system in VGA mode to correct the video configuration problem.
To restart the system in VGA mode:
1. Power down and restart the system.
2. On systems running Windows NT, select the Windows NT Workstation 4.00
[VGA mode] option at the boot screen.
On systems running Windows 95 or Windows 98, press the
F8 key when Starting
Windows 95... or Starting Windows 98... displays on the screen, then select
Safe Mode.
When the operating system desktop displays, right-click the desktop background and select
Properties. The Display Properties dialog displays. Check for the following common
configuration problems and solutions.
u
A multi-sync monitor is connected to the system, but a multi-sync monitor type is not
selected, and the display driver cannot determine this by querying the monitor. Select
an appropriate multi-sync monitor type.
u
A selected resolution, depth, or refresh rate is not supported by the multi-sync monitor.
Try using different video display settings.
u
The Dual Screen option is selected, but only one video card is detected. Clear the Dual
Screen option.
u
A multi-sync monitor is selected, but a monitor with different video timings is
connected to the system. Select the appropriate monitor type.
To Next Page
Loading...
