22
u
The monitor selection doesn’t match the multi-sync monitor attached to the system.
Restart the system in VGA mode, then select a new monitor.
u
A graphics resolution and color depth has been selected that exceeds installed display
memory. Restart the system in VGA mode, then open Display in the Control Panel to
reinstall and configure the display driver as described in the video display adapter
documentation delivered with the system.
After you’ve configured the video display, restart the system and select the non-VGA version
of the appropriate operating system to use the new configuration.
If problems persist, contact the Customer Response Center for help.
Configuring Audio
Your system was delivered with an installed Creative Labs Sound Blaster 16 audio card.
This is a 16-bit Industry Standard Architecture (ISA) card that contains the system’s audio
ports and MIDI/game port. If you purchased a multimedia keyboard for your system, see the
keyboard documentation for detailed information on connecting it to the system’s audio
ports.
You can configure the microphone and speaker audio levels by using the Volume Control
utility, available as a speaker icon on the Taskbar. For more information on using the sound
control programs, see the operating system documentation and Help.
For more information, see the Sound Blaster document delivered with the system.
Configuring Networking
If you purchased a network adapter with your system, it was installed before shipment. You
must configure the operating system to use the network adapter. To do this, you may have to
install network driver software and network adapter control software, and then change
operating system settings to enable networking. Before you configure networking, make sure
that the system has an installed network adapter, and that the network adapter is connected
to a network.
To configure networking, open Network in the Control Panel. Follow the instructions in the
dialogs to set up the system to use a network. Be sure to set up the appropriate network
protocols, such as TCP/IP, for the network to which you are connecting the system.
On a system running Windows NT, after installing network protocols, reinstall the
appropriate Windows NT Service Pack software as recommended by Microsoft.
To Next Page
Loading...
