54
Display Activity
When set to Monitor, this option enables event monitoring on the video display. If set to
Monitor and the computer is in a power saving state, the BIOS watches for display activity.
The computer enters the Full On state if any activity occurs. The BIOS reloads the Standby
and Suspend timeout timers if display activity occurs. The settings are Monitor and Ignore.
The Optimal default setting is Ignore.
Device 6 (Serial port 1), Device 7 (Serial port 2)
Device 8 (Parallel port)
Device 5 (Floppy disk)
Device 0 (Primary master IDE), Device 1 (Primary slave IDE)
Device 2 (Secondary master IDE), Device 3 (Secondary slave IDE)
When set to Monitor, these options enable event monitoring of the specified hardware
device. If set to Monitor and the computer is in a power saving state, the BIOS watches for
activity on the specified device. The computer enters the Full On state if any activity occurs.
The BIOS reloads the Standby and Suspend timeout timers if activity occurs on the specified
IRQ line.
The settings for each option are Monitor and Ignore. The Optimal default setting is Ignore.
LAN Wake-Up
The Optimal default setting is Disabled.
PC98 Power LED
The Optimal default setting is Disabled.
FAN OFF at Suspend
The Optimal default setting is Enabled.
RTC Wake-Up
The Optimal default setting is Disabled.
Hour
The Optimal default setting is N/A.
To Next Page
Loading...
