Chapter 6: Network settings
40 TruVision DVR 12 User Manual
To set up multicasting:
1. From the menu toolbar, click Network Settings > More Settings.
2. Enter a Multicast IP address.
Note: When adding a device to the Network Video Surveillance software, the
multicast address must be the same as the DVR’s multicast IP.
3. Click Apply to save the settings.
Configuring the server and HTTP ports
You can change the server and HTTP ports from the default settings in the
Network Settings window. The default server port is 8000 while that of the default
HTTP port is 80.
Note: The server port has a port range of 2000 to 65535 and is used for remote
client software access. The HTTP port is used for remote internet browser
access.
To change the default ports:
1. From the menu toolbar, click Network Settings > More Settings.
2. Enter the new Com Port and HTTP Port values.
Configuring the RTSP service port
The RTSP (Real Time Streaming Protocol) is a network control protocol
designed for use in entertainment and communications systems to control
streaming media servers.
To configure RTSP service port:
1. From the menu toolbar, click Network Settings > More Settings.
2. Enter the RTSP port value. The default value 554.
3. Click Apply to save the settings.
Telnet setup
For Technical Support only.
To Next Page
Loading...
