EasyManuals Logo

Interlogix TruVision Installation Guide

Interlogix TruVision
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
32 Installation Guide
Terminal resistor settings (non-IR
cameras only)
Follow these instructions to set the terminal resistor for the
TVP-2401/TVP-4401.
1. Remove the bubble from the TVI PTZ dome.
2. Unscrew the four screws on the inside base of the
camera to remove the PTZ drive from the housing.
3. Locate the two pins near the corner of the dome drive
base.

Table of Contents

Other manuals for Interlogix TruVision

Preview: User Manual
User Manual169 pages
Preview: Configuration Manual
Configuration Manual68 pages
Preview: Operator's Guide
Operator's Guide4 pages
Preview: Installation Manual
Installation Manual20 pages
Preview: Quick Start Guide
Quick Start Guide16 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Interlogix TruVision and is the answer not in the manual?

Interlogix TruVision Specifications

General IconGeneral
BrandInterlogix
ModelTruVision
CategoryDVR
LanguageEnglish

Related product manuals