Intermec easycoder f2 User Manual

Intermec EasyCoder F4 – Installation & Operation Ed. 344
Chapter 7
Setting Up the Printer
Description
The setup controls the printer in regard of serial communication,
media feed, and print speed, and specifi es which types of media and
ribbon are loaded in the printer.
Check the list of the printer’s default setup on the next page to
see if they matches your requirements. If not, you will have to
change the setup using one of the methods described below. The
setup may also be changed, manually or automatically, by certain
application programs.
• Setup Mode
- Press the <Setup> key on the printer’s built-in keyboard
to enter the Setup Mode.
- Select the Setup option in Intermec Shell to enter the
Setup Mode.
- Execute the Intermec Fingerprint SETUP instruction to
enter the Setup Mode.
See Chapter 8, “Setup Mode” in this manual.
• Intermec Shell
- Use Terminal Setup option to change the setup remotely
from the host.
Note that Intermec Shell automatically sets up the printer in
regard of communication when an application is selected. See
Chapter 9, “Intermec Shell” in this manual.
• Intermec Fingerprint
- Use setup strings to change individual setup parameters
remotely from the host.
- Use setup fi les to create sets of setup parameters remotely
from the host.
See SETUP statement in the Intermec Fingerprint v7.xx,
Reference Manual.
• Intermec Direct Protocol
- Use setup strings to change individual setup parameters
remotely from the host.
See Intermec Direct Protocol v7.xx, Programmer’s Guide.
• EasySet Bar Code Wand
- Scan a Code 128 bar code containing the setup parameter id.
and the desired value or choice.
See Appendix 4, “EasySet Bar Code Wand Setup.”

Intermec easycoder f2 Specifications

General

Brand	Intermec
Model	easycoder f2
Category	Barcode Reader
Language	English