Intermec easycoder f2

Intermec EasyCoder F2 – Installation & Operation Ed. 2 69
Chapter 8 Intermec Shell Startup Program
To exit the Terminal Setup program, e.g. after having changed
the setup, you must select the Reboot option after having stepped
through all the facility options, as illustrated below:
----------------
SHELL
PRINT SETUP
----------------
(Y / N / B):N
----------------
SHELL
TESTFEED
----------------
(Y / N / B):N
----------------
SHELL
TEST LABEL
----------------
(Y / N / B):N
----------------
SHELL
DEFAULT SETUP
----------------
(Y / N / B):N
----------------
SHELL
SOFTWARE UPDATE
----------------
(Y / N / B):N
----------------
SHELL
REBOOT
----------------
(Y / N / B):Y
Terminal Setup, cont'd.
Exiting Terminal Setup