Intermec EasyCoder F4 – Installation & Operation Ed. 3 45
Chapter 7 Setting Up the Printer
Default Setup
The printer’s default setup is listed below:
Ser-Com "uart1:"
Baud rate: 9600 bps
Character length: 8 bits
Parity: None
Stop bits: 1 bit
RTS/CTS: Disable
ENQ/ACK: Disable
XON/XOFF, data to host: Disable
XON/XOFF, data from host: Disable
New line: CR/LF
Receive buffer: 300 bytes
Transmit buffer: 300 bytes
Feedadjust
Startadjust: 0
Stopadjust: 0
Media
X-start: 24
Width: 832
Length: 1200
Media type: Label (w Gaps)
Paper type: Thermal Transfer
Ribbon constant: 90
Ribbon factor: 25
Label offset: 0
Low diameter; 36
Contrast: ±0%
Print Defi nes
Print speed: 100 mm/sec.
Reading the Current Setup
The printer’s current setup values can be read from the printer’s
display window by browsing through the Setup Mode, or from the
host by browsing through the Terminal Setup of Intermec Shell.
You can list the printer’s current setup by printing test label #5 in
the Setup Mode or by using Intermec Shell.
The current setup can be sent to the host via the standard serial
communication channel using a SETUP WRITE "uart1:"
statement (see Intermec Fingerprint v7.xx, Reference Manual).
To Next Page
Loading...
Need help?
General
