Intermec EasyCoder F4 – Installation & Operation Ed. 38
Chapter 1 Introduction
Safety
Precautions
Product Labeling
Intermec assumes no responsibility regarding the CE Directive if
the printer is handled, modifi ed, or installed in any way other than
described in Intermec’s manuals.
Caution
• Read this manual carefully before connecting the printer.
• Moving parts are exposed when the side door is open, so ensure
that the door is closed before you operate the printer.
• Do not open the front/left-hand cover. Dangerous voltage!
• Do not remove the bottom plate. Dangerous voltage!
• Do not put your fi ngers inside the print mechanism when
the power is on.
• Place the printer on an even surface which can support its weight
of approximately 7 kg (15.5 pounds) plus supplies.
• Do not spray the printer with water. If you are using a hose to clean
the premises in an industrial environment, remove the printer or
protect it carefully from spray and moisture.
• Carefully read the warning text on the envelope before using
a cleaning card.
The machine label is attached to the printer’s rear plate and contains
information on type, model, and serial number as well as AC voltage.
It also contains various signs of approval.
To Next Page
Loading...
Need help?
General
