Intermec easycoder f2 User Manual

Intermec EasyCoder F4 – Installation & Operation Ed. 366
Chapter 8 Setup Mode
Setup Mode Overview, Part 5
(Intermec Fingerprint v7.40)
• Press <Setup> to exit the Setup Mode.
SETUP:
NET-COM, NET1
SETUP:
PRINT DEFS
SETUP:
MEDIA
SETUP:
FEEDADJ
SETUP:
SER-COM, UART1
Standard Setup Mode
See Overview Part 1
Standard Setup Mode
See Overview Part 1
Standard Setup Mode
See Overview Part 2
Standard Setup Mode
See Overview Part 2
Use <.> and <0> - <9>
to set netmask.
Use <C> to erase
Use <.> and <0> - <9>
to set IP address.
Use <C> to erase.
Read Read Set
NETWORK:
IP SELECTION
SETUP:
NETWORK
NETWORK:
IP ADDRESS
IP ADDRESS:
192.168.1.79
NETMASK:
255.255.255.0
NETWORK:
NETMASK
Use <.> and <0> - <9>
to set default router.
Use <C> to erase.
NETWORK:
DEFAULT ROUTER
DEFAULT ROUTER:
192.168.1.1
RARP
BOOTP
DHCP
IP SELECTION:
MANUAL
CR
LF
NET-COM,NET1:
NEW LINE
NEW LINE:
CR/LF
If an optional an EasyLAN 100i interface board is installed in the printer, additional menus will be displayed.

Intermec easycoder f2 Specifications

General

Brand	Intermec
Model	easycoder f2
Category	Barcode Reader
Language	English