Intermec EasyLAN Interface Kit Installation Instructions 7
2
Setup in Fingerprint
This chapter explains how to set up the network com-
munication via the printer’s built-in keyboard and
display. It applies to any printer model running the
Intermec Fingerprint v8.00 (or later).
It is also possible to perform the same setup using
the Fingerprint instruction SETUP (see the Intermec
Fingerprint Programmer’s Reference Manual).
Setting up the network communication is not
restricted to authorized service technicians!
For information on how to set up the network com-
munication in printer’s running IPL, refer to Chapter
3.
To Next Page
Loading...
Need help?
General
