Intermec EasyLAN Interface Kit Installation Instructions 9
Chapter 2 — Setup in Fingerprint
Setting the Network Parameters
There are four methods for setting the IP address. DHCP, BOOTP,
and DHCP+BOOTP let the server assign a temporary IP address to
the printer. Which method to choose depends on the server. DHCP,
BOOTP, and DHCP+BOOTP also sets the netmask, default router,
and name server automatically. If the server neither supports DHCP nor
BOOTP, or if you want to set a permanent IP address manually, use the
MANUAL option. In this case, you will also have to set the netmask,
default router, and name server manually via the printer’s keyboard.
Always consult your network administrator before assign-
ing a permanent IP address to avoid having more than one
device with the same IP address in the network.
IP Selection
• Press the Setup key on the printer’s built-in keyboard. This message
appears in the display window:
SETUP:
SER-COM, UART1
• Repeatedly press the → key until the following message appears:
SETUP:
NETWORK
• Press the ↓ key. The display shows:
NETWORK:
IP SELECTION
• Press the ↓ key. The display shows by default:
IP SELECTION:
DHCP+BOOTP
• Here, you can select the method for assigning the IP address for the
printer as discussed above. There are four options; DHCP+BOOTP,
MANUAL, DHCP, and BOOTP.
• Use the ← or → keys to browse the stack of options. When the
desired option is displayed, press the Enter key.
To Next Page
Loading...
Need help?
General
