Intermec EasyCoder PF2i - Default Chapter; Table of Contents

Preface
Contents
Introduction ................................................................................. iv
Printer Firmware........................................................................... iv
Installation Kit.............................................................................. iv
1
Physical Installation
EasyCoder PF2/4i printers.............................................................2
EasyCoder PM4i printers...............................................................3
All Models .....................................................................................3
2
Setup in Fingerprint
Setup Methods...............................................................................8
Setting the New Line Parameter.....................................................8
Setting the Network Parameters .....................................................9
IP Selection .....................................................................9
Reading or Setting the IP Address..................................10
Reading or Setting the Netmask, Default Router, and
Name Server..................................................................10
3
Setup in IPL
Setup Methods.............................................................................14
Setting the Network Parameters ...................................................14
IP Selection ...................................................................14
Reading the IP Address..................................................15
Reading the Netmask, Default Router,
and Name Server ...........................................................15
Using ARP’n’PING to set an IP Address........................16
4
Accessing the Printer’s Home Page
Using the Web Browser................................................................22
Intermec EasyLAN Interface Kit Installation Instructions iii