Intermec EasyCoder PF4i Installation Instructions

EasyLAN Wireless Interface Kit Installation Instructions 15
Chapter 2 — Physical Installation
• Put the cover aside on a soft cloth or similar to avoid scratches.
• Remove any optional interface board or blind cover plate fi tted on the
rear plate.
• Remove any present EasyLAN Ethernet interface installed in the
printer including cables etc.
• Remove the present rear plate like this:
- Loosen but do not remove the two #T20 Torx screws that hold
the rear plate and the #T20 Torx screw that holds the rear bottom
corner of the CPU board.
- Carefully manipulate the rear plate out of the groove in the chassis.
Allow the CPU board to fl ex a little to be able to get the connectors
out of their slots.
• Install the rear plate included in the kit in reverse order and tighten all
three screws.
• Reinstall any optional interface board or blind cover plate previously
removed.
• Continued on page 18.

Intermec EasyCoder PF4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power consumption (standby)	15 W
Power consumption (printing)	300 W
Media thickness	3/7.5 mm
Maximum label width	104 mm
Maximum label length	0.4 m
Maximum roll diameter	152.4 /213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Product color	Blue, Silver
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	405 mm
Width	244 mm
Height	178 mm
Weight	8000 g