Intermec PB50

Chapter 2 — Configuring the Mobile Printer
PB50 and PB51 Mobile Printer User Guide 33
A printer cannot initiate a Bluetooth connection. The other device,
such as a mobile computer, must request a connection with the
printer. The printer then accepts or rejects the connection. Use
Intermec Settings on the mobile computer to enable the Bluetooth
settings on the printer.
If the printer has a Bluetooth connection, it can also connect to
Bluetooth scanners, such as the SF51 and the SR61 Cordless scanners.
You can create the bar code labels you need to connect the printer to a
Bluetooth scanner using EasySet software. To create these bar codes,
you need to know the Bluetooth Device Address (BDA)and the PIN of
the printer. You can download a free version of EasySet from the
Intermec website at www.intermec.com.
Each printer equipped with a Bluetooth radio has a unique BDA. You
can find the BDA on the certification label located on the bottom of
the printer.
For information on how to set up Bluetooth communications with
your mobile computer, see your mobile computer user manual.
To set up Bluetooth communications with a scanner
1 Download and install EasySet.
2 Create the following bar code labels using EasySet:
• Administrator reset factory defaults
• Bluetooth parameters - security - not active
• Bluetooth parameters - connect/disconnect - compose BT
address
• Bluetooth parameters - security - compose PIN:
Note: For maximum security, Intermec recommends that you set
a Bluetooth passcode. The default passcode is 1234.