Intermec PB50

Chapter 2 — Configuring the Mobile Printer
PB50 and PB51 Mobile Printer User Guide 37
Use the following sections to set most of your wireless
communication settings. For help with additional commands and
information, see either the Fingerprint Command Reference Manual or
the IPL Command Reference Manual. You can download both
documents from the Intermec website at www.intermec.com.
Configuring Wireless Printing Using IPL
Use the following procedures to configure your printer with IPL for
wireless printing.
To configure the printer to use WEP authentication
1 Send the following commands to login as an admin and set the
SSID:
<STX><ESC>.x,su -p pass admin<ETX>
<STX><SI>ws,SSID,
xxxxx<ETX>
where xxxxx can be from 0 to 32 ASCII characters, not including
the double quote.
2 Send the following commands to configure the WEP keys. The
following example sets WEP key 1 to 1234 and enables WEP key 1.
<STX><SI>ws,WEP1, 0x0001020304<ETX>
<STX><SI>ws,.WEP_KEY,1<ETX>
3 Send the following command to activate the settings:
<STX><SI>ws,ACTIVE,1<ETX>
Weak signal
Poor signal
No signal
Understanding the 802.11 Radio Icons (continued)
Icon Description
Note: The default administrator password is “pass.” If you have
changed the password, use your password instead of “pass.”