Intermec PB50

Chapter 2 — Configuring the Mobile Printer
42 PB50 and PB51 Mobile Printer User Guide
• Send the following commands to set a common name for
server 1 and server 2:
setup "8021x",".SERVER_CN1","xxxxxxxxxx"
setup "8021x",".SERVER_CN2","xxxxxxxxxx"
where xxxxxxxxxx can be a value from 0 to 64 characters.
• Send the following command to make sure your values match
those used by the access point:
setup write "8021x","uart1:"
• You may need to send the following command several times for
the wireless station to connect:
setup "wlan","ACTIVE","1"<ETX>
Configuring the Printer Settings
You can change the configuration settings of the printer from:
• the Control Panel, or display.
• the host PC using PrintSet.
• the host PC using the command line.
• the printer home page.
• the SmartSystems Console.
For more information on the IPL and Fingerprint menu systems, see
“IPL Setup Menu” on page 80.
Changing Configuration Settings from the Control Panel
You need to start Setup mode before you can change configuration
settings from the Control Panel or display. For more information on
starting Setup mode and navigating through the settings, see
“Understanding Setup Mode” on page 23.
The top levels of the Setup menu are organized in a one-way loop.
Each level has several sub-levels.
Note: The Setup menu is not available when using ESC/P.