Intermec PB50

Chapter 3 — Troubleshooting and Maintaining the Mobile Printer
PB50 and PB51 Mobile Printer User Guide 59
Possible Printer Error Icons and Messages
Error Icon Error Message Description
Pause The print job is paused.
Paper out (IPL)
Out of Paper
(Fingerprint)
The printer is out of paper. Load a new roll of
media. For help, see “Loading Media” on
page 14.
Testfeed not
done
The printer did not perform a testfeed before
it printed out test labels. It is important to
perform a testfeed because it calibrates the
printer sensors.
To perform a testfeed:
• Press the Feed button for more than 2
seconds (Fingerprint or ESC/P)
• Open and close the media door, then press
the Feed button (IPL)
‘
Printhead hot The printhead is overheated and needs to
cool down. In IPL, wait for printing to resume
automatically. In Fingerprint and ESC/P,
your print job is lost.
Upgrading The printer is loading new firmware.
LSS too high
LSS too low
These errors can occur when you run a test
feed without any media installed, or if you
have incorrect media settings.
Load the printer with media (see “Loading
Media” on page 14), run Test mode (see
“Understanding Extended Test Mode” on
page 25), and select the appropriate media
type.
IP configuration
error
The printer does not have a network IP
address. Wait for the printer to acquire an IP
address before continuing.
IP link error The printer does not have a network
connection.