Preface
iv Intermec EasyLAN Wireless Interface Kit—Installation Instructions
Introduction
This Installation Instructions booklet describes how to install an
EasyLAN Wireless network interface in an EasyCoder PF2i, PF4i, PF4i
Compact Industrial, or PM4i printer and how to connect it to a LAN,
WAN, Intranet, or Internet network via a wireless connection.
The installation instructions describes how to physically install the inter-
face board in a printer and how to set up the IP address, netmask, default
router, and name server. The instructions end when you have the print-
er’s home page up and running. From there, please refer to the Intermec
EasyLAN User’s Guide on the attached CD-ROM.
This interface kit must only be physically installed by an
authorized service technician. The device is country/region
specifi c and must be ordered for the correct country/region.
Use of this device in other region than shown on the device
home page/test label may violate applicable law.
Printer Firmware
The printer must either be fi tted with Intermec Fingerprint v8.10 (or
later) or IPL v2.10 (or later). In Intermec Fingerprint, the network port
is addressed as device "net1:" (communication channel #5).
Installation Kit
The EasyLAN Interface Kit contains:
• One EasyLAN adapter board complete with radio module fi tted
• Rear plate (for EasyCoder PF2/4i-series printers only)
• RJ-45 plug (for EasyCoder PM4i only)
• One light guide
• One hexagonal threaded spacer
• One antenna extension cable
• One antenna
• One cable clip
• One cable tie
• One CD-ROM with software and manuals
• This Installation Instruction booklet
The only tools required for the installation are #T10 and #T20 Torx
screwdrivers and a small wrench.
To Next Page
Loading...
