Interscience FlexiPump - Flow Direction of the Pump; Anti-Drop System; Sound; Contrast

15
3.6.1 Flow direction of the pump
The arrow displayed in front of “FLOW DIRECTION” indicates the direction towards which goes
the pump and consequently the direction in which the tubing must be placed. If the arrow indicates a
direction from left to right like this : then the source must be placed on the left side of the pump
and the container on the right side.
To change the direction of the pumping, please select the line and then press on the rotating button. Get
back to the main screen by pressing on the “esc.” button.
Note: The direction of the pumping is a general parameter, meaning that when using the FlexiPump
®
,
the direction will be set whatever the programm you use.
3.6.2 Anti-drop system
The Anti-drop option enables to prevent that a drop shows up at the end of the tubing at the end of a
distribution. Such a drop can be a trouble if the user shakes the tubing and the drop falls into the
container, because it would alter the precision.
To prevent that a drip appears, the pump goes back and sucks the drop back in the tubing. This
operation can take a fraction of a second after dispensing.
To activate or disactivate the option, select the “ANTI-DROP” line and then press on the rotating
button. Go back to the main screen by pressing on the “esc.” button.
3.6.3 Sound
FlexiPump
®
makes a little sound after each operation.
To activate or disactivate the sound, select the line “SOUND” and then press on the rotating button.
Go back to the main menu by pressing on the “esc.” button.
3.6.4 Contrast
This option lets you adjust the contrast on the screen. Depending on the brightness of your environment,
you may want to increase or decrease the contrast.
Select the “CONTRAST” line and press on the rotating button. Set up the contrast by turning the
button and press again to validate.
3.6.5 Date/time
The setting of the date and time guarantees traceability (on FlexiPump
®
Pro).
To set the date and time, select the line “DATE / T I M E ” and press the rotating button. With the
rotating button, set up the date and press the button. Repeat the operation to set up the number of the
month and the year. Proceed the same way to set up the time and minutes.
3.6.6 Language
FlexiPump
®
displays its information in french or english. To set up the language, select the language line
“LANGUAGE” and press the rotating button to go to a language to another.