25
3.9.2 Using the FlexiPump
®
to fill in Dry-bags from Oxoid
(Thermo Fisher Scientific)
For this, we recommend you to use a FlexiPump
®
Pro with a tubing of inner diameter of 8 mm to obtain
the maximum flow of 2.5 L/min. This will help to fill the 20 L Dry-bags
in 8 minutes.
This requires replacing the tip of the stainless steel tubing with the trocar for broth bags. (ref. 513 020).
3.10 Using the handy gun (ref. 561 001)
For a highly precise work, you can use the handy gun (Also see chapter 2.1)
How to install the handy gun
- Connect the Jack 3,5 mm connector at the back of the
unit of the FlexiPump
®
.
- Insert the stainless steel nozzle in the gun.
Be careful to aim in the slot where you can distinguish white
rollers.
- To take out the stainless steel nozzle, un-clip it by
translating it down. Be careful not to press too much.
3.11 Advanced features (FlexiPump
®
Pro)
FlexiPump
®
Pro has a serial port to connect with a thermal printer. If a printer is connected to
it, FlexiPump
®
Pro prints a report at the end of each program.
FlexiPump
®
Pro has an USB port to be connected with a computer. When a computer is
connected to it, FlexiPump
®
Pro sends a report to the computer at the end of each program.
Push
Clips the tubing
To Next Page
Loading...