Intertek FT Series - Flooring & Leveling

The FT Series Floor Standing, Heating Only Boiler
Page 13
WARNING
4.2 Flooring & Leveling
Make sure that the oor and structure of the installation location are su󰀩cient to support the full installed
weight of the boiler, including water content of the heat exchanger and related piping. Failure to ensure the
oor and structure of the installation location are structurally sound before installation of the boiler can result
in structural failure, substantial property damage, severe personal injury, or death.
This boiler is approved for installation on combustible flooring, but must never be installed on carpeting.
Installing this boiler on carpeting could result in re, property damage, severe personal injury, or death.
In order for the condensate to properly ow out of the collection system, the area where you locate the
boiler must be level. Location must also fully support the weight of the lled boiler.
CAUTION
CORRECT INCORRECT
Boiler leveling feet are factory installed for your convenience.
* If small adjustments are required, tilt the boiler either to the left or right side and adjust the proper
leveling feet.
Do NOT tip the boiler backwards or forwards as the protruding base on the front may interfere with
the oor and may deform.
Note:
When moving the boiler, use hand holds in left and right side panels to pick the boiler.
Do not slide boiler along the oor on its boiler feet, as this may damage the feet.