To Next PageTo Next PageWhy is my Intex PureSpa SC-10 so noisy in filtration mode?
If your Intex Swimming Pool is too noisy in filtration mode, ensure the control panel, back cover and all inlet/outlet are securely connected. Also, ensure the ground is level, firm and smooth. Replace the failed filter motor with a new one.
Why are the Intex PureSpa SC-10 air bubbles not as strong as before?
If the air bubbles in your Intex Swimming Pool are not as strong as before, ensure the o-ring is in place between the control base air outlet and spa tub air inlet connections. Finger tighten all nuts. Use repair patch to repair any puncture.
How to level Intex PureSpa SC-10 pump connectors with spa connectors?
To level the pump connectors with the spa connectors on your Intex Swimming Pool, elevate the pump with wood or another type of insulated material to bring the pump’s connectors level with the spa’s connectors.
How to fix no LED display on Intex Swimming Pool?
If there is no LED display on your Intex Swimming Pool, press any button to reactivate the control panel. Reset the GFCI/RCD, restart all over again and charge the control panel again. Make sure the surface between the back of the control panel and the control base recessed channel is clean, dry and free of obstruction.
General| Category | Swimming Pool |
|---|---|
| Type | Inflatable Hot Tub |
| Heating System | Yes |
| Air Jets | 120 |
| Digital Control Panel | Yes |
| Built-in Water Filtration | Yes |
| Chemicals Dispenser | Yes |
| Outer Diameter | 201 cm (79 in) |
| Height | 28 inches |
| Maximum Temperature | 40°C (104°F) |
| Material | Fiber-Tech material |
| Cover | Included |
| Model | PureSpa SC-10 |
Urgent warnings for drowning, injury, and electrical shock risks.
Key precautions for safe operation, covering electrical and user risks.
Procedure for testing the GFCI/RCD and cautions on water chemistry.
Specific information and warnings regarding the spa suction fitting.
Guidelines for preparing the installation site for the spa.
Instructions for charging and installing the spa control panel.
Step-by-step guide to inflating the main spa tub structure.
Instructions for inflating the air bladder within the spa cover.
Procedures for deflating spa tub/cover and understanding air release.
Steps for filling the spa with water and installing the cover.
Guidelines for using, adding, and managing salt for the sanitation system.
Overview of control panel buttons and basic operations like power and filter.
Detailed explanation of operating jets, bubbles, sanitizer, and heating.
How to program the heater start time and operating duration.
Adjusting temperature, display, and understanding heater function examples.
How to adjust jet nozzle output and a warning about water temperature.
Steps for activating, programming, and testing the sanitation system.
Procedures for maintaining clean water and key chemical balance readings.
Understanding calcium hardness, SI, and adjustment principles.
Guides for adjusting total alkalinity and lowering pH levels.
Methods for increasing pH and adjusting calcium hardness.
Instructions for cleaning and maintaining the filter cartridge and electrolytic cell.
Detailed steps for cleaning the electrolytic cell and using test strips.
Procedures for draining, cleaning the tub, and maintaining the air valve.
Steps for preparing the spa for storage, including draining and cleaning.
Resolving issues related to air pressure, leaks, and water flow.
