Intex QS500 - Troubleshooting Guide

329
A
SAVE THESE INSTRUCTIONS
English
(329IO) MODEL ECO5220/5230 & 6220/6230 SALTWATER SYSTEM WITH E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 05/23/2024
Page 25
TROUBLESHOOTING GUIDE
INSUFFICIENT
SODIUM
HYPOCHLORITE
WHITE FLAKES IN
THE WATER
NO LED DISPLAY
•
Insufficient operating hours of the
Saltwater System.
•
The salt level in the pool water is less
than 2000 ppm. This is insufficient.
•
Sodium hypochlorite loss due to
intense sunlight exposure.
•
The bather load has increased.
•
Clogged or dirty electrolytic cell.
• High UV level exposure.
•
Excessive calcium hardness is
present in pool water.
•
No power supply.
• RCD has not reseted.
•
A power fuse has blown.
•
LED failure.
•
Increase the daily Saltwater System operating
time. See “Operating Instructions”.
•
Check the salt level with the Test Kit. Adjust
as needed. See “Salt & Pool Water Volumes”.
•
Use a pool cover when the pool is not in use
and/or when the unit is operating.
•
Remove the cell for inspection, clean it if
necessary. See “Maintenance”.
•
Cover the pool with a pool cover for 2 days
with the device running and then test the water
using the test strips.
•
If the pool is clean and clear, add stabilizer to
the water and then test the water with the
device running.
•
Drain about 20% to 25% of the pool water and
add fresh water to decrease the calcium
hardness. Inspect the electrolytic cell for scale
buildup. Clean the electrolytic cell if necessary.
•
Find out the switch and turn on.
• Reset the RCD.
• Contact Intex Service Center.
PROBLEM CAUSE SOLUTION