8
Replacing Heel Strap
NOTE: For this procedure, refer to FIGURE 2.2.
1. Remove the locking bolt (5 mm Allen key and 10 mm Spanner) that secure the
footrest tube to the footrest support.
2. Remove the lower footrest assembly.
3. Remove the mounting screw, strap pin that
secure the heel strap to the footplate.
4. Slide heel strap over footrest tube.
NOTE: When securing the heel strap to the
footrest assembly, tighten the mounting screw
and strap pin until they are secure.
5. Using the mounting screw, strap pin, secure
the heel strap to the footplate.
6. Using the locking bolt with 5 mm Allen key and
10 mm Spanner, secure the footrest tube to the
footrest support.
7. Securely tighten (5 Nm).
One Piece Footboard Adjustments (Depth & Width)
NOTE: For this procedure, refer to FIGURE 2.3.
1. Loosen Mounting Screw (M6) securing the depth position.
2. Adjust to desired depth (3 positions), firmly tighten Mounting Screw (M6).
3. Loosen 4 Locking Bolts (M5) securing the footboard central part.
4. Slide outside parts to the desired width using the pre-set width position.
5. Firmly tighten 4 Locking Bolts (M5).
NOTE: For angle adjustment refer to Installing Angle Adjustable Footplate paragraph.
To Next Page
Loading...
