SECTION 4—PACKAGING, HANDLING, AND SET-UP
Part No 1114836 25 IVC
™
Bed Series
FIGURE 4.6 Adjusting and Reconnecting the Head Section Pull Tube
Installing the Casters
WARNING
Ensure that the locking casters are installed diagonally from each other and are
locked. Otherwise damage or personal injury could occur.
NOTE: For this procedure, refer to FIGURE 4.7 on page 26.
DEALER NOTE: ALWAYS locate locking caster in the same location on each bed end so that they
will always be assembled diagonally opposite each other when inventory is mixed.
NOTE: Position the two locking casters so that they will be diagonally opposite from one another
when the bed is assembled.
NOTE: If two locking casters are not included with the bed, contact a qualified dealer.
Hitch Pin
Lift-Arm Slot
Clevis Pin
Inner Pull Tube
Outer Pull Tube Adjusting Hole
Side Frame
Clevis Pin
Nylon Washer
Head Spring Pull
Tube
Grommet/Washer
DETAIL "B"
DETAIL "A"
Hitch Pin
Grommet/Washer
To Next Page
Loading...
Need help?
General
