Sln: 3-wire control, FWD: Forward running, REV:
Reverse running
Note: For dual-line running mode, when
FWD/REV terminal is valid, if the VFD stops due to
stop command given by other sources, it will not
run again after the stop command disappears
even if the control terminals FWD/REV are still
valid. To make the VFD run again, users need to
trigger FWD/REV again, eg, PLC single-cycle
stop, fixed-length stop, and valid STOP/RST stop
during terminal control. (see P07.04).
These function codes define corresponding delay
of the programmable input terminals during level
variation from switch-on to switch-off.
Setting range: 0.000–50.000s.
Note: After a virtual terminal is enabled, the state
of the terminal can only be changed in
communication mode. The communication
address is 0x200A.
To Next Page
Loading...