- 11 -
Default as DHCP status , 9828 will auto get the IP address from user`s router by the suggest
hardware connection as following :
9828 ------- Router ------- PC ( with Web browser )
If there is no assigned IP to 9828 by the connection , the 9828 will change to FIX IP address :
⚫ Default IP: 192.168.1.169 (While this is no DHCP apparently)
If can’t see the IP in the area of Local Devices of IPEDIT.exe. Please check if use more
than one network card ( include dynamic network card ) , disable the Firewall and Anti
Virus software temporally and try again.
2.) Select the 9828 device and the device information will pop up on the right.
3.) Check to see that the gateway IP and the IP Address (9828) match user current network.
If not, type in the correct information, then hit the “ Submit “ button to save changes.
For example:
If user has the following information regarding the 9828 and user network
User PC Network :
Computer IP Address: 192.168.1.122 , Gateway: 192.168.1.1
Sub Net mask: 255.255.255.0 , Port: 80
User 9828 in IPEDIT :
9828 IP Address: 192.168.100.34 , Gateway: 192.168.100.1
Sub Net mask: 255.255.0.0 , Port: 80
Since the IP Address of the 9828 is : 192.168.100.34
User will need to make sure that the first 3 segments of user 9828 IP Address
must match the first 3 segments of user gateway IP.
First 3 Segment of Gateway Address: 192.168.1.X
So user new IP Address for the 9828 should be: 192.168.1.XXX
New Network Information
9828 IP Address: 192.168.1.26
Gateway Address: 192.168.1.1 , Local Computer IP Address: 192.168.1.122
Sub Net mask: 255.255.255.0 , Port: 80
4.) Press the “ Rescan “ button to see if changes have been made.
5.) Double click on the device in the local device section and an IE web browser
with the device login will pop up.
6.) Type in the default Login and IP Address to enter the device.
Default Login : admin , Default : 12345678
To Next Page
Loading...
