IPG Photonics LightWELD - Step 2: Connect the Weld Head Adapter and Components

Step 2:Connect the Weld Head Adapter and Components
The weld head adapter and components can be assembled from left to right, as shown below.
1
Screw the Contact Tip into the Weld Head Adapter.
2
Insert the Liner into the Weld Head Adapter until it stops.
3
Manually screw the Nut on to the Weld Head Adapter.
4
Tighten the Nut on the Weld Head Adapter using a 12mm wrench.
5
Push the Housing Tube over the barbed end of the Nut. Move the housing tube back and forth while
simultaneously pushing, until it is flush with the nut.
1 Getting Started
LightWELD WireFeeder Set-Up Guide
5