MIG-185CMT
11
Additional settings
2T- / 4T - mode / SPOT mode.
Use the button (7) to set the 2T/4T mode or “SPOT” mode. In 2T mode, you always need the torch
button while welding. In 4T mode, briefly press and release the torch button, even at the end when you
want to stop welding. Meanwhile keep the button relaxed. The SPOT mode is intended for fast multi-
point joining of materials.
Inductance/Wire feeding speed at the start of arc/Pre-gas/Post-gas
Ind - inductance
Ind - range -10 to +10 - this sets the concentration of the arc. -10 - narrow and tall weld, +10 wide and
short weld.
Wire feeding speed at the start of arc
Range 0 to 10. 0 means slow, 10 means fast.
Pre-gas
Range 0 to 2.
Post-gas
Range 1 to 5.
To Next Page
