Iridium 9505A - Placing a Call

42 Using Your Phone
Placing a Call
To place a call, your phone must be powered on,
have a SIM card inserted, be unlocked, and be in
contact with the satellite network. See “Accessing
the Network” on page 147 for network information.
You can enter a phone number up to a maximum of
20 digits. The digits are displayed in two rows, 16
digits in the top line and four digits in the next line.
Dial a Number
1. Rotate and fully extend the satellite
antenna. “See Holding the Phone” on
page 40.
Tip: Press and
hold
0 to
get +
Tip: If you
make a
mistake, press
C once to
delete the last
digit, or press
and hold
C to
clear all digits.
2. Enter the number using the digit keys. As
you begin entering digits, you will see
Call?.
You must enter the phone number in
international format:
[international access code,
00, or +]
[country code] [phone number]
Note: If you are calling another Iridium
satellite subscriber, dial the subscriber’s
Iridium number.
3. Press
O. You will see Calling followed by
the number you dialed.
You will see either the flashing message
Calling or the flashing messages Calling,
Registering...
, and the phone will play a
series of setup tones.
If the call connects and is answered,
Connected
appears on the display for a few seconds, followed
by
End Call?.
06Using-kg.fm Page 42 Wednesday, November 3, 2004 9:36 PM