IRIS IRMA MATRIX User Manual

iris-GmbH | Ostendstrasse 1 – 14 | 12459 Berlin | Germany Rev. 1.2 | 2016-02
www.irisgmbh.de Subject to alterations!
Automatic passenger counting
IRMA – Infrared Motion Analyser
5
th
generation
IRMA MATRIX
Start on the PC via Ethernet
Operating Instructions
For the service software variants of
 IRMA-MATRIX-Configuration
 IRMA-MATRIX-Visualization
 IRMA-TestRide-IRMA MATRIX

IRIS IRMA MATRIX Specifications

General

Brand	IRIS
Model	IRMA MATRIX
Category	Accessories
Language	English

Summary

General Information

Symbols and Abbreviations

Explains the various symbols and abbreviations used throughout the manual for clarity.

Brief Document Description

Provides a concise overview of the document's purpose and the IRMA MATRIX system.

Preparation for Connection

Required Equipment List

Details the necessary hardware and software components for connecting the IRMA MATRIX sensor.

Work Step Overview

Outlines the sequence of steps required for the PC and sensor setup process.

Network Configuration

Network Architecture Settings

Specifies required network configurations, including UDP port requirements for communication.

PC IP Address Configuration

Explains how to set the IP address on the PC to enable communication with the sensor.

Setting a Secondary IP Address

Details the procedure for adding a second IP address to the PC's network adapter.

WLAN Deactivation

Importance of Switching Off WLAN

Emphasizes disabling WLAN to prevent potential communication problems.

Sensor Connection Procedures

Connection via SCON-S-CAN-ETH-23-Kq-x-y

Step-by-step guide for connecting the sensor using the SCON-S-CAN-ETH-23-Kq-x-y connector.

Connection via SCON-S-ETH-22-Kq-x-y

Instructions for connecting the sensor using the SCON-S-ETH-22-Kq-x-y connector.

Starting the Service Software

Initial Software Setup

Guides on initial setup for service software, including modifying target properties.

Important Start-Up Notes

Key actions to perform before starting the service software, including sensor power and reset.

DIST500-Configuration Tool

Details the DIST500-Configuration software for sensor parameter entry.

DIST500-Visualization Tool

Explains the DIST500-Visualization software for process and height monitoring.

IRMA TestRide Software

Describes the IRMA TestRide software for determining counting accuracy.

Restoring PC Settings

Resetting Network Adapter

Instructions for resetting modified network adapter settings after service work.