IRIS IRMA MATRIX

3/15
Starting IRMA MATRIX on the PC via Ethernet
Rev. 1.2
2016-02
Table of contents
1 General .......................................................................................................................... 4
1.1 Symbols / abbreviations used .................................................................................................... 4
1.2 Brief description ............................................................................................................................. 4
2 Preparation ................................................................................................................... 5
2.1 Equipment required ...................................................................................................................... 5
2.2 Overview of the necessary steps of work ............................................................................... 6
3 Checking the settings in the network architecture ..................................................... 6
4 Making the IP settings (PC) .......................................................................................... 6
4.1 Changing (setting) the IP address of your PC network adapter ........................................ 7
4.2 Setting as a second IP address ................................................................................................... 8
5 Switching off the WLAN ............................................................................................. 10
6 Connecting the sensor ................................................................................................ 11
6.1 PC connection with a standard connector of the type sCON-S-CAN-ETH-23-Kq-x-y11
6.2 PC connection with a standard connector of the sCON-S-ETH-22-Kq-x-y type ........ 12
7 Starting the service software ..................................................................................... 13
7.1 Before the first run of the service software program ....................................................... 13
7.2 Important at each start of the software............................................................................... 14
7.2.1 DIST500-Configuration_3.3.1.142 (or higher) .................................................................... 14
7.2.2 DIST500-Visualization_4.2.0.112 (or higher) ...................................................................... 14
7.2.3 IRMA TestRide 2.8.1.37 (or higher) ......................................................................................... 14
8 Restoring the initial state at the PC ........................................................................... 15
Table of illustrations
Figure 1: Select Internet protocol type 4(TCP/IPv4), right: Enter IP address ........................ 7
Figure 2: How to enter the extended PCP/IP settings ................................................................ 8
Figure 3: Entering the IP address for IRMA MATRIX as a second entry .................................. 9
Figure 4: PC connection with sCON-S-CAN-ETH-23-Kq-x-y standard ................................. 11
Figure 5: PC connection with sCON-S-ETH-22-Kq-x-y ............................................................. 12
Figure 7: Entry in the "Properties" window of a service software tool ............................... 13