IRIS IRMA MATRIX User Manual

15/15
Starting IRMA MATRIX on the PC via Ethernet
released
Rev. 1.2
2016-02
8 Restoring the initial state at the PC
On conclusion of the work with the sensor on the PC the modified settings for the network
adapter must be reset. This can be omitted only if the IP address of the sensors was made
as a second IP entry.
In order to prevent unnecessary PC reboots, it has proven successful to restore the previous
settings of the network adapter even before the PC-sensor connection is interrupted. For
this purpose observe the instructions in section 4.1, page 7, up to item 3. Here the setting
"Get IP address automatically" must be activated again.

IRIS IRMA MATRIX Specifications

General

Brand	IRIS
Model	IRMA MATRIX
Category	Accessories
Language	English