Need help?Do you have a question about the IRIS IRMA MATRIX 2 and is the answer not in the manual?
Provides critical guidelines for optimal sensor placement and orientation.
Details the process of mounting the IRMA MATRIX sensors.
Provides instructions for installing the IRMA gateway unit.
Outlines methods for connecting a service PC to the sensors.
Guides on configuring sensors using the DIST500-Configuration software.
Explains how to connect the IRMA gateway to a PC for configuration.
Guides on configuring the IRMA A21 gateway using the A21 Assistant software.
Describes how to verify the installation using the IRMA-A21-Windows service software.
Details the mounting of a single sensor in the center of the door area.
Explains the mounting procedure for the DIST500-A surface mount sensor.
Details the mounting steps for the standard sCON-S connector.
Describes mounting flush mount sensors using the standard sCON-S connector.
Details the mounting process for flush mount sensors using the sCON-F-12 connector.
Details EMC-compatible installation and grounding requirements per EN 50153.
Explains the CAN bus cabling procedures for IRMA MATRIX sensors.
Details various sensor parameters adjustable in the configuration tool.
General| Type | Thermal Imaging Camera |
|---|---|
| Detector Type | Uncooled microbolometer |
| Thermal Sensitivity (NETD) | < 50 mK @ 30 °C |
| Accuracy | ±2 °C or ±2 % of reading |
| Operating Temperature | -15 °C to +50 °C |
| Spectral Range | 8 – 14 μm |
| Operating Humidity | 10% to 90% non-condensing |
To Next Page
