/74
R2 CAN Installation manual
1. Cut the rectangular cutout in the cove, see (4) in Fig. 9, p. 20.
The drilling pattern is enclosed in the Annex to this document.
Fig. 10: Setting, adjusting and tightening of the cylinder head screws
2. Screw the cylinder head screws by hand lightly into the threaded holes on the rear of the
sensor so that they are adjusted and sit reliably in their holes.
3. Insert the sensor from below through the rectangular cutout of the cove (4) so that the
plastics window faces the vehicle interior (see Fig. 9, p. 20).
Ensure the correct orientation of the sensor relative to the passengers boarding the vehicle
and alighting from it; see Fig. 5, p. 15.
Fig. 11: Pushing the spring holders in place and screwing them tight
4. Push the pre-assembled spring holders from both sides along the guide groove under
the adjusted cylinder head screw so that the screw comes to sit in the center of the hole
of the spring holder (see Fig. 11 left). The sensor is now in the correct position.
5. Then tighten the cylinder head screws step by step alternatingly with an Allen key (see
Fig. 11Fehler! Verweisquelle konnte nicht gefunden werden., right).
The maximum tightening torque for the cylinder head screws must not exceed 3 Nm.
The leaf springs in the mounting set are overstretched in the mounted condition and will
not flex back into their original shape. If a mounting set is to be used several times, it must
be ensured that it is used only for coves of identical or greater thickness. The mounting set
To Next Page
Loading...
Need help?
General
