IRIS IRMA MATRIX 2

47
/74
IRMA MATRIX
R2 CAN Installation manual
released
Rev. 1.6
2018-09
8.2 Configuration using DIST500-Configuration
The service software "DIST500-Configuration 3.9.6.187"
7
and higher is used for the
configuration of the system. The Configuration Tool instructions describe the individual
steps of the configuration in detail.
8.2.1 Update to the current service software required!
Fig. 27: Version of the service software program - Menu point "?" - please check!
IRMA MATRIX requires a new service software version from version 3.9.6.xxx on or higher.
It is available on the Internet on http://www.irisgmbh.de/ (file name: DIST500-
Configuration_3.9.6.xxx.zip). It is downward compatible with its predecessor.
Only the up-to-date software program enables you to utilize the full sensor functionality.
8.2.2 Notes on the firmware
Fig. 28: Sensor selection and firmware
We continue developing the sensor firmware (here in Fig. 28 e.g. "Application
2.1.270.6635") to reflect technological progress. As downward compatibility with the
predecessor version is ensured, different firmware versions in different deliveries are by no
means a functional restriction.
Firmware versions having "1" as the first Fig. of the version designation must not be
installed any more.
7
Below named “Configuration Tool”