IRIS IRMA MATRIX 2

48
/74
IRMA MATRIX
R2 CAN Installation manual
released
Rev. 1.6
2018-09
8.2.3 Sensor selection
In the sensor selection dialogue the option “UIP-over-UDP” (see Fig. 28) must be active as
otherwise no sensors are shown at all. As a rule, “UIP-over-UDP” is pre-set.
8.2.4 Option DHCP
Fig. 29: DHCP option in the tab „Ethernet“
“DHCP” – The Dynamic Host Configuration Protocol is included in Configuration Tool.
“DHCP” allows the automatic assignment of a network configuration to the sensor(s). For
this purpose, you need to have a DHCP server in the network.
Check the field if you can integrate IRMA MATRIX into the network using an existing DHCP
server.