Iris Technology Operator's Manual
QuietPower 1800 (QP-1800) Doc 287.F701 / 100412
Page 18 of 56 Rev 12 APR 2010
Section 2
Installation
CAUTION
Review the Important Safety Instructions found at the beginning of this
manual and read this entire section, paying particular attention to the
CAUTION and WARNING statements, before proceeding with the
installation.
2.1 General
This section contains instructions for installing the QuietPower Inverter. After installing the unit
and making wiring connections, DO NOT turn the unit on. Proceed to Section 3, Operation,
which provides operating instructions.
2.2 Requirements for Installation
You will need the following tools and hardware to properly install the QuietPower Inverter:
Wrench for DC terminals (½” or 13 mm)
Wrench for Vibration Isolators (optional, 7/16”)
2.3 Installing the Inverter
Install the inverter as follows:
1. Find a suitable location to install the QuietPower Inverter. Refer to paragraph 2.4,
Locating the Inverter, for more information.
2. Install the inverter. Refer to paragraph 2.5, Mounting the Inverter, for more
information.
To Next Page
Loading...
General