Iris Technology Operator's Manual
QuietPower 1800 (QP-1800) Doc 287.F701 / 100412
Page 38 of 56 Rev 12 APR 2010
5.2.2 Cleaning
The QuietPower Inverter contains sophisticated internal electronic circuits that can be damaged
if debris or foreign matter enters the inverter casing. Clean the QuietPower Inverter and NATO
Cable in accordance with Table 8.
CAUTION
Do not use harsh or abrasive cleaners on the QuietPower inverter or
NATO cable. Do not use petroleum-based products of any kind. Damage
can result if these precautions are not followed. Use only a non-abrasive
cloth dampened with soap and water to clean inverter and NATO cable.
Do not attempt to flush the unit with liquids of any kind.
Table 8: Cleaning (External)
Be sure the inverter is switched OFF and
disconnected from any power source for at least 5
minutes.
Check inverter for cleanliness.
Clean inverter casing, control panel, and mounts using a
non-abrasive cloth dampened with soap and water (only).
Do not use let water enter the inverter through the front or
rear vents, switch, control panel, circuit breaker, or AC
receptacle.
Check NATO Cable for cleanliness.
Clean NATO Cable using a non-abrasive cloth dampened
with soap and water (only).
To Next Page
Loading...
General