Iris Technology Operator's Manual
QuietPower 1800 (QP-1800) Doc 287.F701 / 100412
Page 7 of 56 Rev 12 APR 2010
Specific Warnings and Hazards of this Device
The following are specific warning, cautions and hazards related to the installation, use,
maintenance and service of this device.
WARNING
FIRE AND SHOCK HAZARD. MAKE SURE THE CABLE IS
DISCONNECTED FROM 24 VDC POWER SOURCE PRIOR TO INSTALLING
CABLE ONTO INVERTER TERMINALS. FAILURE TO DISCONNECT
CABLE FROM 24 VDC POWER SOURCE (NATO PLUG) FIRST MAY
RESULT IN FIRE, SEVERE ELECTRIC SHOCK, OR DEATH.
WARNING
BEFORE MAKING CONNECTIONS, ROUTE THE POSITIVE AND
NEGATIVE BATTERY WIRES DIRECTLY TO THE DC CONNECTION
TERMINALS ON THE QUIETPOWER INVERTER FIRST.
WARNING
SHOCK HAZARD. MAKE SURE GROUND CONNECTIONS ARE
MAINTAINED BETWEEN THE INVERTER, VEHICLE, AND GROUND ROD
(IF APPLICABLE). FAILURE TO DO SO COULD RESULT IN A POTENTIAL
SHOCK HAZARD.
WARNING
DO NOT DISASSEMBLE THE QUIETPOWER INVERTER. ONLY
QUALIFIED ELECTRONICS MAINTENANCE TECHNICIANS ARE
PERMITTED TO REPLACE THE FUSE. ATTEMPTS TO SERVICE THE
INVERTER BY UNQUALIFIED PERSONNEL MAY RESULT IN A RISK OF
ELECTRIC SHOCK OR FIRE. REFER TO SECTION 7, WARRANTY AND
SERVICE, FOR INSTRUCTIONS ON SERVICING THE INVERTER.
To Next Page
Loading...
General